![]() iOS releases tend to be more strict enforcing this as time goes on, and iOS 16.5 validates more comprehensively than iOS 16.4. Find the responsible plug-in using any method of your choice (bisect, remove one by one, etc.) and reach out to the plug-in author. For example a thermostat reporting a temperature of -9999 will produce this message. See my comment to 'out of compliance' means that the device is initially setting characteristics outside the allowed range. If your iPhone can reach your Homebridge machine via mDNS but your active HomeKit hub cannot reach your Homebridge machine via mDNS, then devices will add OK but after a minute or two, go to 'No Response'. After adding devices to HomeKit on your iPhone, if you are using the 'new architecture', as soon as an iCloud sync occurs (usually 1-2 minutes after adding), control will transfer from iPhone->device to active HomeKit hub->device. VE devices with firmware versions 1.6.0 and 1.6.1 could not connect to Vision. Eero or Google Wi-Fi and everything will 'just work' out of the - you also have a multicast routing issue. Refer to the Software Compatibility matrix near the end of this document to. If this is beyond your ability, just get a good mesh network e.g. Look for settings called 'multicast DNS', 'IGMP proxy', 'IGMP enhancement' etc. you will need to set up multicast forwarding between the network segments. If you are using an enterprise router setup/VLANs/discrete APs/etc. Home routers purchased in the last 5 years will do this automatically, and not require any setup. If that doesn't fix things (and 80% of the time it will not), it means your network isn't set up to route multicast traffic properly. First step is to run Homebridge natively on your machine - not in Docker or a VM. the UI) by IP but adding to HomeKit gives 'unable to find accessory', 100% of the time it means you have a multicast routing issue on your network. If you can access the Homebridge machine (e.g. This will rebuild the internal HomeKit - this is not a Homebridge (or Home Assistant) issue. Other 5%: sign out of iCloud on your iPhone and HomeKit hubs, then back in. If you are using iOS 16.5, there is a known bug whereby adding new devices if you are not the home 'owner' causes this. Otherwise it's impossible to - devices adding successfully then disappearing a couple of minutes later (when the phone does an iCloud sync) is an endpoint/iCloud cache coherency issue. ![]() If you have a different issue, create a new GitHub issue. Please help us to help you by not posting new issues in a GitHub thread that's about a different issue. There are so many completely different issues here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |